UNIPRO 3005 UniGo Basic, 01-03-001

  • Model: sk2216
  • Manufactured by: UNIPRO
Add to Cart:


Lap memory: 200
Log memory: 120 minutes
Channels logged: Lap time, position, RPM, 2 x temperature, speed, gear, voltage. Logged at 10 Hz
Sensor inputs: RPM, 2 x temperature*, speed*, trigger, external power
Trigger: Magnet, infrared, active loop
Split times: Magnets
Real-time-clock: No
Expandable: No
Display type: 256 x 160 pixels, 16 gray scales
Backlight: No
LED warnings: 5 high-brightness, fully programmable
Data upload: USB high-speed via optional USB cable
Casing: Lightweight plastic
Waterproof: Yes
Dimensions: 131.5 x 94.0 x 18.0 mm (5.18" x 3.70" x 0.71")

* Shared connector: Optional cable splitter needed

UniGo 3005 is both a Laptimer and a Data Logger. It means that all data are stored in the Laptimer at 10 times per second. It makes it possible to transfer the results to a PC or MAC for further analyzing. The included analyzer program will give you the complete overview together with the possibility to compare results between drivers, training sessions and heats.

The kit contains the Laptimer with free choice of receiver (magnet, loop or IR), RPM wire, power cable and a battery holder for six AA batteries. It gives you the possibility to measure lap times and engine revolutions.

The instrument comes complete with magnetic foot for lap times and a tachometer cable, power cord for AA batteries.

Sampling frequency at 60Hz.

Expandable with UNIBOX, (therefore there is the possibility to multiply the available channels for example, the pedal and steering sensors), it does not have the backlighting, it does not have the predisposition for GPS antenna.

The RECV output is by time / speed channel. It is therefore possible to mount both the time probe and the speed probe (one only if we have also installed a magnet receiver, therefore either front wheel or rear axle) by installing the black splitter cod. 10-04-090.

The TEMP output instead is the temperature channel for detecting the water and exhaust gas temperature.
If we want to do the two measurements at the same time it is necessary to install the gray splitter code 11-02-003.

The EXP output is dedicated both to external power supply and to expansion via UNIBOX.

The instrument has 5 high-contrast LEDs fully programmable.


User guide

Product Brief


Customers who bought this product also purchased...

Recently Viewed
facebook youtube instagram twitter
cc pagamenti

Copyright © 2000 - 2020 "Ingegnando s.r.l." unipersonale. C.S.I.V. 10.000 € - P.IVA 01599810502 - Iscritta alla CCIAA di Pisa REA 139784
Sede Legale: Vicolo Keplero 8, 56021 - Cascina - Magazzino: Via A. De Gasperi 39, 56021 Cascina (Pisa) Italia

Mob. +39 335.812.9176 Tecnico / Tel.Fax +39 050.711.105

Powered by Zen Cart opzione.com - Your IP Address is: | Cookie Policy | GDPR Privacy